Allied Telesis AT-8900, RAPIER I, X900-48FE, AT-8700XL manual Set ip filter, Set ip route preference

74 Internet Protocol (IP) Enhancements Release Note

destination is unknown. You may need to increase the timeout period if you are communicating with devices that are slow to respond. The default is 1 second.

Example To set the router or switch to wait 2 seconds after you ping a device before declaring that the device is unreachable, use the command:

set ip arpw=2

set ip filter

Syntax SET IP FILter=0..999 {ACtion={INCLudeEXCLude}POLIcy=0..15PRIOrity=P0..P7} SOurce=ipadd [SMask=ipadd] [SPort={port-nameport-id}] [DEStination=ipadd [DMask=ipadd]] [DPort={port-nameport-id}] [ICMPCode={icmp-code-nameicmp-code-id}] [ICmptype={icmp-type-nameicmp-type-id}] [LOG={4..1600DumpHeaderNone}] [OPtions={FalseOFFONNOTrueYES}] [PROTocol={protocolAnyIcmpOspfTcpUdp}] [SEssion={AnyEstablishedStart}] [SIze=size] [ENTry=1..255]

Description This command changes a pattern in an IP traffic filter, policy filter, priority filter or routing filter. You can now specify a greater range of filter numbers in the set ip filter command. The new range is between 0 and 999.

set ip route preference

Syntax SET IP ROUte PREFerence={DEFault1..65535}

PROTocol={BGP-extBGP-intOSPF-EXT1OSPF-EXT2

OSPF-INTErOSPF-INTRaOSPF-OtherRIPALL}

The protocol parameter specifies which protocol’s routing table is updated with the new preference value. If all is specified, all protocol routing tables are updated with the new preference value.

Software Version 2.8.1 C613-10477-00 REV B