Allied Telesis RAPIER I Vlan-namecannot be a number or ALL, VID of the control Vlan PRImaryport

18	create epsr			Software Reference
		Parameter	Description (cont.)
		CONtrolvlan	The identifier of the control VLAN.
			Note that you must first create the VLAN specified. To do this, use the
			create vlan command. For details of this command, see the Switching
			Chapter of your switch’s Software Reference.
			Default: no default
			vlan-name	A unique name for the control VLAN. This name can be from
				1 to 32 characters long. Valid characters are uppercase and
				lowercase letters, digits, the underscore, and the hyphen.
				The vlan-namecannot be a number or ALL.
			1..4094	The VID of the control VLAN
		PRImaryport	The port number of the primary port for the EPSR instance on this switch.
			Only configured for the master node.
			Default: no default
		HEllotime	The rate that the master node transmits its TAPS protocol health control
			messages. The time can be specified from 100 milliseconds (100ms), to
			32767 seconds (32767s). Only configured for the master node.
			If no unit suffix is specified, the value is read as seconds. If ms is specified,
			the value must be a multiple of 100 ms.
			Default: 1s
		FAilovertime	The time period that a master node allows for a healthcheck frame to circle
			the loop before declaring that the EPSR ring has broken. This time period is
			measured from the time the frame leaves the master node’s primary port,
			to the time it is received at the master node’s secondary port.
			The time2 can be specified from 200 milliseconds (200ms) to 65535
			seconds (65535s). If no unit suffix is specified, the value is read as seconds.
			If ms is specified, the value must be a multiple of 100 ms.
			The failovertime must be at least twice the value of the hellotime.
			Default: 2s
		RIngflaptime	The minimum number of seconds that a master node must remain in the
			failed state (before moving to the complete state), even if the ring has
			recovered from its fault condition. This delay is to limit unnecessary blocking
			and unblocking of the secondary port when a link in the ring is flapping
			(intermittently recovering from its fault).
			Default: 0
		TRap	Whether SNMP traps will be sent when the EPSR instance changes state.
			Default: enabled
			ENAbled	Traps will be sent as long as the SNMP module is
				appropriately configured.
			DIsabled	Traps will not be sent.

Examples To create an EPSR instance called blue, with this switch acting as the master node, vlan2 as the control VLAN, and port 1 as the primary port, use the command:

cre epsr=blue mode=mast con=vlan2 pri=1

Related Commands add snmp targetaddr (SNMPv3) add snmp targetparams (SNMPv3) create snmp community (SNMPv1 & v2) create vlan

destroy epsr set epsr set epsr port show epsr