Motorola LS4208 Removing the Interface Cable, Connecting a Synapse Cable Interface, Connecting Power (if required)

1 - 4 Symbol LS4208 Product Reference Guide
Removing the Interface Cable
To remove the inter f ac e ca ble :
1. Unplug the installed cable’s modular connector by depressing the connector clip with the tip of a screwdriver.
2. Carefully slide out the cable.
3. Follow the steps for Installing the Interface Cable on page 1-3 to connect a new cable.
Connecting a Synapse Cable Interface
Symbol’s Synapse Smart Cables enable interfacing to a variety of hosts. The appropr iate Synapse cable has the
built-in intelligence to detect the host to which it is connected.
Figure 1-3 Synapse Cab le Connection
1. Plug the Synapse adapter cable (p /n 25-32463-xx) into the bottom of the scanner, as described in Installing the
Interface Cable on page 1-3.
2. Align the ‘S’ on the Synapse adapter cable with the ‘S’ on the Synapse Smart Cable and plug the cable in.
3. Connect the other end of the Synapse Smart Cable to the host.
Connecting Power (if required)
If the host does not provid e po we r to th e sca nn e r, an external power connection to the scanner is required. To
connect power:
1. Connect the interface cabl e to the bottom of the scanner, as described in Installing the Interface Cable on page
1-3.
2. Connect the other end of the interface cable to the host (refer to the host manual to locate the correct port).
3. Plug the power supply into the power jack on the interface cable. Plug the other end of the power supply into
an AC outlet.
NOTE Refer to the Synapse Interface Guide provided with the Synapse cable for detailed setup instructions.
Synapse Adapter Cable
To Scanner
Synapse Smart Cable
To host