Installing the Universal Connector Cover | Motorola XTS 3000

Introduction

Universal Connector Cover

Installation and Removal

!CAUTION

When the universal connector is not in use, keep it covered with the

universal connector cover.

Installing the Universal Connector Cover

1.Looking at the antenna side of the radio, insert the top (ﬂat) hooked end of the cover into the slot on the top of the radio, above the universal connector. Press downward on the cover’s top to seat it in the slot.

2.While holding the cover seated in the top slot, insert the cover’s bottom (rounded) hooked end into the slot below the universal connector. Press ﬁrmly inward on the cover’s bottom until it snaps in place.

Top Top Hooked End Slot

Bottom

Hooked End

Bottom

Slot

Removing the Universal Connector Cover

1.Looking at the antenna side of the radio, insert a ﬂat-bladed screwdriver into the area between the lower end of the universal connector cover and the slot below the universal connector.

2.Pry upward on the cover’s lower end until it disengages from the radio.

9

Image 13

Motorola XTS 3000 manual Universal Connector Cover Installation and Removal, Installing the Universal Connector Cover

Contents

Digital XTS 3000 Basic Model Preface Notations Used in This Manual General Radio Operations Common Radio Features Computer Software Copyrights Special Radio FeaturesAdditional Information Inspection Introduction Radio Controls Programmable Switches and Buttons Programmable Features Bicolor LED Switches, Buttons, Knobs, and Indicators Radio Operating-Frequency Table Antenna Installation and Removal Antenna Identiﬁcation Table Installing the Battery Battery Installation and RemovalRemoving the Battery Installing the Belt Clip Belt-Clip Installation and RemovalRemoving the Belt Clip Installing the Universal Connector Cover Universal Connector Cover Installation and RemovalRemoving the Universal Connector Cover Introduction Radio On Turning the Radio On and OffRadio Off Zone Selection Selecting a Zone and ChannelChannel Selection Receiving/Transmitting Adjust the Volume Control Knob for a Time-Out Timer General Radio FeaturesLow-Battery Indication Entering the Emergency State Emergency PTT Switch Common Radio Features Emergency Keep-Alive Exiting the Emergency State Individual Calls Receive Only Call Response Answering an Individual CallButton Call Response Button PL Defeat Repeater Access Selecting Repeater or Direct Operation Repeater/Direct Scan Deleting Nuisance Channels Turning Scan On and OffDynamic Priority Change Conventional Operation Only Smart PTT Selecting Squelch Operation Dynamic Regrouping Special Radio Features Reprogram Request Select Enable/DisablePress the Reprogram Request Button if programmed, see PTT-ID Transmit Selecting Secure or Clear Transmissions Secure Operation KEY Loading Managing Encryption Selectable Power-Level Busy Override Trunking System ControlsDispatcher-Interrupt Failsoft Site Lock Out-of-RangeSite Change Glossary Sound Tone Name Occurs Alert Tones High-Pitched Tone Charging Batteries Battery Charging and DisposalRecycling or Disposal of Batteries Hanil Metal Recycle CO Helpful Tips Radio Care CleaningHandling Service Air Bag Safety Information Index Index General Radio Features Questionnaire Business Reply Mail FCC Safety Standards 68P81083C70 6881072C75