Motorola XTS 3000 manual Turning Scan On and Off, Deleting Nuisance Channels

Common Radio Features

Turning Scan On and Off

Place the Scan On/Off Switch (if programmed, see page 2) in the “scan on” position or the “scan off” position.

A

B

C

2
page
See
your
for
radio’s-	.
feature
programming
control

Deleting Nuisance Channels

When the radio scans to a channel that you do not wish to hear (nuisance channel), you can temporarily delete the channel from the scan list.

1.When the radio is locked onto the channel to be deleted, press the Nuisance-Delete Button (if programmed, see page 2). Repeat this step to delete additional nuisance channels.

Note	Priority channels and the selected channel
	cannot be deleted using the nuisance-
	delete feature.

2.The radio continues scanning the remaining channels in the list. To resume scanning the deleted channel, you can change channels or leave and re-enter scan operation.

A

B

C

2
page
See
your
for
radio’s-	.
feature
programming
control

Dynamic Priority Change (Conventional Operation Only)

While the radio is scanning, the dynamic priority change feature lets you temporarily change any channel in a scan list (except the priority-one channel) to the priority-two channel. The present priority-two channel becomes a non-priority channel. This change remains in effect until scan is turned off, then scanning reverts back to the preprogrammed state.

1.When the radio is locked onto the channel to be designated as priority- two, press the Dynamic Priority Button (if programmed, see page 2).

Note

The priority-one channel cannot be changed to priority-two.

2.The radio continues scanning the remaining channels in the list. To resume scanning the preprogrammed priority-two channel, you must leave and re-enter scan operation.

23