Moxa Technologies C168P user manual Installation Guide, RS-485 Mode

RS-485 Mode

The Opt8J supports only 2-wire RS-485 communication. Set the respective switch to ON position to use RS-485 interface. This means the port can transmit data only when RTS is asserted, and receive data only when RTS is not asserted (half-duplex).

Refer to Chapter “Connection Option (Opt8x) and Cable Wiring” for RS-422/RS- 485 cable wiring. And also to Chapter “Serial Programming Tools” for Opt8J RS- 485 programming details.

Installation Guide

This section gives a brief summary of how to install the C168P under each supported operating system. The installation is simple and involves the following stages:

Configure C168P with io-irq.exe. Install the C168P board

Install the software from the diskette Configure the driver for the board and ports

Connect the devices with the cable

Restart the system

Check the driver initialization status

If the system restart successfully, you may develop your applications or

execute the desired applications

See Chapter “Hardware Installation”

See Chapter “Software Installation” for respective OS

See Chapter “Connection Cable and Cable Wiring”

See Chapter “Software

Installation”

See Chapter “Serial

Programming Tools”

1-8C168P User’s Manual