Moxa Technologies CP-132U user manual Using PComm, Using Event Log

Software Installation

4.Select an Rx FIFO Trigger from the Rx FIFO Level pull-down list. Rx FIFO trigger levels from High to Low are available, with the default set to High (120 bytes). Check Set the change to all ports check-box to apply the just defined Rx FIFO Trigger to all ports.

5.Select a Tx FIFO Size from the Tx FIFO Level pull-down list. Tx FIFO Levels from High to Low are available, with default value set to High (128 bytes). Check Set the change to all ports check-box to apply the just defined Tx FIFO Size to all ports.

	CP-132UL V2/CP-132UL-I V2		CP-132UL/CP-132U-I
	Tx FIFO	Rx FIFO	Tx FIFO	Rx FIFO
High	128	120	64	56
Middle	64	60	32	28
Low	1	1	1	1

Unit: Bytes

6.Click [OK] in the Port X dialog box to confirm the port settings, and then click [OK] in the Property dialog box to complete the port settings.

Using PComm

The PComm Diagnostic program is a very useful tool for checking the status of MOXA’s multiport boards. It provides internal and external testing of IRQ, TxD/RxD, UART, CTS/RTS, DTR/DSR, etc. This program can be used to make sure that MOXA’s boards and ports are working properly.

To start this program, click on Start Æ Programs Æ PComm Lite 2000 ÆPComm Diagnostic.

NOTE: If you do not have the PComm software, you can download the free version of the software from Moxa’s website at www.moxa.com.

Using Event Log

To use Event Log to check MOXA boards, click Start Æ Settings Æ Control Panel Æ

CP-132U Series User’s Manual 3-9