NOTE
NOTE
Double check that all Smartio
Once the system restarts, you may check the event log issued by the MOXA driver to see if the board’s ports have been initialized successfully.
Enter the [Administrative] group, click the [Event Viewer] icon, and then select [Log] and [System] to check a message similar to “MOXA
If an error message similar to “Cannot find any configured MOXA Smartio/Industio series board!” pops up, refer to the Troubleshooting chapter for possible solutions.
Once the board and the driver are installed and the driver restarts successfully, you can begin to develop applications with the PComm library (see “Serial Programming Tools”) or the Microsoft Win32 API. You can also use applications such as Terminal Emulator (see “Serial Programming Tools”), a PComm utility, or HyperTerminal, to transmit/receive data, as well as Remote Access Service to provide
Configuring the Board and Ports
Re-Configuring Port Settings
If the driver is already installed, and you only wish to
[Start] Æ [Programs] Æ [MOXA Utility] Æ [MOXA Smartio/Industio Configuration Panel] Æ [Property], and then refer to the instructions in the previous section, “First Time Driver Installation.”
1.Open the [Control Panel], click on the [Network] icon, and select the [Adapters] tab.
2.Click on MOXA Smartio/Industio Family Adapter from the Network Adapters list to highlight it, and then click on [Properties] to open the MOXA Smartio/Industio Configuration Panel dialog box to change port settings and advanced FIFO configuration.
