Fiber Driver® EM316SW-XY
PN 1288003-001, Rev D2 25
4.3 EM316LNXNM-OT Command Line Interface (CLI)
The EM316LNXNM-OT provides command line interface (CLI), SNMP, and graphical
administration options for a Fiber Driver chassis system. This section introduces the CLI for the
Linux-based network management (EM316LNXNM-OT) module.
EM316LNXNM-OT management commands are specific to each module.
Some commands applicable to the EM316SW-XY and a managed host chassis are illustrated in
this manual. The box below lists a few of the sample commands addressed in this document. Refer
to the Table of Contents for a list of commands addressed here, and refer to EM316LNXNM-OT
documents for more detail.
– show
– show version
– show slots
– show x.x
– ?
– list
– lin / no lin
– show digital-diagnostics
– show config
– show defaults
– description <name>
– shutdown / no shutdown
– loopback / no loopback
Figure 25 -- EM316LNXNM-OT general commands for EM316SW-XY modules
Some of these commands apply to both slot-level and port-level contexts as described in the
navigation portion of this section. Refer to EM316LNXNM-OT documentation for a more complete
discussion of the Linux-based interface and available commands.