▶Remote Access Configuration
▶Remote Access
The setting enables/disables the remote access function. When set to [En- abled], users may configure the following settings for remote access type and parameters.
▶Serial Port Number, Base Address, IRQ, Serial Port Mode
Use these settings to configure ports for remote access.
▶Flow Control
Flow control is the process of managing the rate of data transmission between two nodes. It’s the process of adjusting the flow of data from one device to an- other to ensure that the receiving device can handle all of the incoming data. This is particularly important where the sending device is capable of sending data much faster than the receiving device can receive it.
▶Redirection After BIOS POST
This setting determines whether or not to keep terminals?console redirection running after the BIOS POST has booted.
▶Terminal Type
To operate the system’s console redirection, you need a terminal supporting ANSI terminal protocol and a
▶VT-UTF8 Combo Key Support
This setting enables/disables the
▶Sredir Memory Display Delay
Use this setting to set the delay in seconds to display memory information.
