MSI MS-91F7 manual IDE Configuration Primary/Third/Fourth IDE Master/Slave

MS-91F7

▶IDE Configuration

▶Primary/Third/Fourth IDE Master/Slave

[Type]	Press PgUp/<+> or PgDn/<-> to select [Manual], [None] or [Auto] type.
	Note that the specifications of your drive must match with the drive
	table. The hard disk will not work properly if you enter improper infor-
	mation for this category. If your hard disk drive type is not matched or
	listed, you can use [Manual] to define your own drive type manually.
[LBA/Large Mode]	Enabling LBA causes Logical Block Addressing to be used in place of
	Cylinders, Heads and Sectors
[Block(Multi-Sector	Any selection except Disabled determines the number of sectors trans-
Transfer)]	ferred per block
[PIO Mode]	Indicates the type of PIO (Programmed Input/Output)
[DMA Mode]	Indicates the type of Ultra DMA
[S.M.A.R.T.]	This allows you to activate the S.M.A.R.T. (Self-Monitoring Analysis &
	Reporting Technology) capability for the hard disks. S.M.A.R.T is a util-
	ity that monitors your disk status to predict hard disk failure. This gives
	you an opportunity to move data from a hard disk that is going to fail to
	a safe place before the hard disk becomes offline.
[32 Bit Data Transfer]	Enables 32-bit communication between CPU and IDE controller

3-7