MTD 60-3754-4 manual Chute Assembly all models, For Models with 4 Way Chute Control Box, Figure

Chute Assembly (all models)

1.Apply a light lubricant (i.e. 3-in-1 oil) to the base of the chute assembly.

2.Place the chute assembly on the lip of the chute adapter. See Figure 3

3.One end of each chute keeper is already attached to the chute flange. Pivot the free end of the chute keeper to align it with the chute flange and push it till it snaps into position. See Figure 4. Repeat with remaining chute keepers.

Chute

Assembly

21

Figure 3

Chute

Assembly

3

Chute Keeper

Figure 4

For Models with 4 Way Chute Control Box

1.Pull the hairpin clip out of the clevis pin on the chute support tube. Save this hardware.

Hairpin Clip	4 Way
	Chute
	Control
	Box
	Clevis
	Pin
	Chute Support
	Tube

Figure 5

Cables

Short

Tube

Chute Support

Tube

Figure 6

2.Position the chute assembly so the chute opening is facing the front of the unit.

3.Place the chute control box on the short tube of the chute assembly and the chute support tube of the chute assembly as shown in Figure 6, cables should be towards the operator.

4.Insert the clevis pin, earlier removed, through the holes on the chute control box and chute support tube. Secure with the hairpin clip. See Figure 5.

For Models with 2Way Chute Control

1.Slip the cables, running from the chute to the handle panel into the cable guide located on top of the engine. See Figure 7 .

Cable Guide

Figure 7

Models with a Chute Directional Control

1.Remove the flat washer and hairpin clip from the end of the chute directional control. Insert the end of the chute directional control into the lower bracket and secure with the flat washer and hairpin clip just removed. See Figure 8.

NOTE: If necessary, the lower bracket can be adjusted. Refer to Chute Bracket Adjustment. in the Adjustment Section.

6