![](/images/new-backgrounds/1110100/110100101x1.webp)
Software/Driver Installation
ConfigMenu Menus
Network Configuration
Call Control Configuration
Data Protocol
Stored Numbers
Port Control Configuration
Help
AT Commands
You can configure the terminal adapters using AT commands, just as you would configure an analog modem. Use this method if you prefer to work with AT commands or if you have a special requirement not addressed by either of the configuration utilities.
To configure the TAs with AT commands:
1.Disconnect the
2.Start a data communication program and select the first and third COM ports to be configured.
3.Referring to records made for your system, enter AT commands in the terminal window of the data communications program.
4.When you finish, use the &W command to save your new configuration and to select it to load automatically when the ISIHP- 2S/2U is turned on.
5.Close the data communications program and reconnect the TA to the network terminator.
For more information, see the online Owner’s Manual.
MultiModemISI Hybrid Series, | 51 |