Multi-Tech Systems ISIHP-2U SCO Open Server 5 Driver Installation, Examining media. Please wait …

Software/Driver Installation

SCO Open Server 5 Driver Installation

The installation utility provided by SCO is called custom. This section provides a brief guide for opening the utility and installing the driver. The instructions below should be used only on SCO Open Server 5 systems. When you have completed the steps below, go to Multi-Tech Installation Script, which immediately follows this section.

1.If installing the driver from your default floppy drive, type custom and press ENTER to open the custom utility. If using a nondefault drive, you must inform your system of the disk drive from where you are doing the installation and the size and capacity of the diskette(s).

2.Select Software and press ENTER.

3.The main menu displays a list of options. Press ENTER to select the highlighted item (default): Install.

4.Select From comsco and press ENTER.

5.Make sure the driver diskette is in the floppy diskette drive and then press ENTER to select the highlighted item (default): Floppy Disk Drive 0. The following message appears:

Examining media. Please wait …

6.The system recognizes you are installing the Multi-Tech Serial Card Driver and prompts you to select the type of installation.

7.Select Full Installation and press ENTER to continue. The following messages appear:

Extracting Files...

Executing Multi-Tech Serial Card Driver Init Script...

8.When installation finishes, this prompt appears:

Do you wish to continue ( y / n / q ):?

Type Y and press ENTER. Proceed with the next section, Multi- Tech Installation Script.

MultiModemISI Hybrid Series, ISIHP-2S/2U 53