Command List | Chapter 4: Serial or Telnet I/O Functions |
4.2Command List
The following table lists all serial/Telnet commands that are used to operate, administer, and maintain the unit. The Utility Port is ready to receive these commands once the
Use the front panel keypad to set initial system configuration values at first installation.
Table 4-1: F-Series Function Commands
Command | Function | Parameters |
|
|
|
F03 | Time/Date Request | MM/DD/YYYYHH:MM:SS |
|
|
|
F18 | Software Version Request | – |
|
| (equivalent to F100 VER) |
|
|
|
F36 | Network Configuration Entry/Request | EA, IP, SM, G |
|
| (equivalent to corresponding F100 commands) |
|
|
|
F53 | Operating Mode Request | – |
|
|
|
F60 | Satellite List Request | – |
|
|
|
F67 | Leap Second Information Request | – |
|
|
|
F72 | Fault Status Request | – |
|
|
|
F100 BASET | 10, 100 | |
|
| (change requires confirmation within 10 seconds) |
|
|
|
F100 DHCP | DHCP Control | ENABLE/DISABLE |
|
| (change requires confirmation within 10 seconds) |
|
|
|
F100 EA | Ethernet Address | – |
|
|
|
F100 IP | IP Address | ### ### ### ### |
|
| (change requires confirmation within 10 seconds) |
|
|
|
F100 SM | Subnet Mask | ### ### ### ### |
|
| (change requires confirmation within 10 seconds) |
|
|
|
F100 G | Default Gateway | #### #### #### #### |
|
| (change requires confirmation within 10 seconds) |
|
|
|
F100 IC | Network Configuration Request | IP, SM, G |
|
|
|
F100 P | Password Change Request | XXXXXXX |
|
|
|
F100 ST | Self Test Results Request | – |
|
|
|
F100 VER | Software Version Request | – |
|
|
|
F100 T | Request Current Time Source | GPS, ACTS, or NTP |
|
|
|
F100 CONFIG | NTP, SNMP and ACTS Configuration | “GET” , “SET”, “NTP”, “SNMP”, “ACTS”, “IP |
|
| ADDRESS”, “YES”, “NO”, “W”, “R” |
|
| (change requires confirmation within 10 seconds) |
|
|
|
F100 LOCK | Remote Lockout | LOCK |
|
| (change requires confirmation within 10 seconds) |
|
|
|
F100 L | Lock Display Request | – |
|
|
|
TimeVault™ User’s Manual |
