Error Action get or set is not specified

Chapter 5: TimeVault-Generated Messages

Error Messages

5.1.6ERROR: Action (get or set) is not specified

Meaning:	You have omitted the “get” or “set” parameter from the F100 NTP
	Configuration command.
Recovery Action:	Re-enter the command, specifying the desired action.

5.1.7ERROR: Can’t open source file <NAME>

Meaning: The file containing the needed data is unavailable.

Recovery Action: Check file location and directory names to verify the path is accurate, then re-enter the command.

5.1.8ERROR: Can’t open dest file <NAME>

Meaning: The destination file is unavailable.

Recovery Action: Check file location and directory names to verify the path is accurate, then re-enter the command.

5.1.9ERROR: Can’t write file <NAME>

Meaning: Data from the source file cannot be copied to the destination file.

Recovery Action: Check file location and directory names to verify the path is accurate, then re-enter the command.

5.1.10ERROR: Configuration failed.

Meaning:	Your attempt to configure new parameters was unsuccessful.
Recovery Action:	Verify parameter values, then re-enter the command.

5.1.11ERROR: Configuration type is not specified

Meaning:	You did not specify the file type.
Recovery Action:	Re-enter the command, specifying ACTS, NTP, and/or SNMP.

5-88

TimeVault™ User’s Manual

6000-100Ch5.fm Rev. D