Multi-Tech Systems MVP110 quick start MultiVOIP Quick Start Guide Remote Site Administrator

MultiVOIP Quick Start Guide

Remote Site Administrator

3.Unpack your MultiVOIP.

4.Connect one end of the power supply to a live AC outlet and connect the other end to the Power connection on your MultiVOIP.

Voice/Fax Channel

Connection

PHONE ETHERNET POWER

FXS

Power Connection

Ethernet Connection

Figure 5. Remote Site Cable Connection

5.Connect a network cable to the ETHERNET 10Base-T(RJ-45) connector on the back of your MultiVOIP.

6.If you are connecting a station device such as an analog telephone, a fax machine, or a Key Telephone System (KTS) to your MultiVOIP, connect one end of an RJ-11 cable to the Voice/Fax Channel 1 FXS connector on the back of the MultiVOIP and the other end to the station device.

7.Turn on power to the MultiVOIP by placing the ON/OFF switch on the right side panel in the ON position. Wait for the Boot LED on the MultiVOIP to go off before proceeding. This may take a couple of minutes.

8.At this time your VOIP network should be fully operational. Dial one of the sites in your network using the dialing directory supplied by your Network Administrator.

32