Multi-Tech Systems MVP120 manual Configuring the Master MultiVOIP

Chapter 4 - Configuring the Master MultiVOIP

Chapter 4 - Configuring the Master MultiVOIP

The following steps provide instructions for configuring your MVP120. The configuration sequence includes IP Protocol default setup, Channel setup, and Phone Directory Database setup. The numbering of steps continues from the previous section.

12.The IP Protocol Default Setup dialog box displays.

The default Frame Type is TYPE_II. If this does not match your IP network, select SNAP from the Frame Type list. The available Frame Type choices are TYPE_II and SNAP.

13.In the Ethernet group, enter the IP Address, Subnet Mask, and Gateway Address unique to your IP LAN.

The IP address is the unique LAN IP address that is assigned to the MVP120, and the Gateway address is the IP address of the device connecting your MVP120 to the Internet.

Click OK when you are finished.

14.The Channel Setup dialog box displays. The four tabs in this dialog box define the Channel Interface, Voice/Fax parameters, Billing/Miscellaneous parameters, and Regional telephone parameters.

Check with your in-house telephone personnel to verify whether your local PBX dial signaling is Pulse or DTMF (tone). Select the regeneration option accordingly.

In the Inter Digit Time box, enter the maximum amount of time between dialed digits in milliseconds that the unit will wait before mapping the dialed digits to an entry in the Phone Directory Database. If too much time elapses between digits, the wrong numbers will be mapped and you will hear a rapid busy signal. If this happens, hang up and dial again. The default setting is 2 seconds.

In the Flash Hook Timer box, enter the amount of time the duration of flash hook signals output on the interface. The default setting is 600 milliseconds.

Multi-Tech Systems, Inc. MultiVOIP User Guide 24