Multi-Tech Systems MVP120 manual Configuring the Slave MultiVOIPs

Chapter 5 - Configuring the Slave MultiVOIPs

Note: After you have enabled the Slave option, the Slave Status button is replaced by the Update button. Once your Phone Directory database has been established, you can click this button to refresh the entries in the Phone Directory Database window.

18.Enter the IP address (204.022.122.118) of the New York Office MVP120 in the Master IP Address box and enable the Send Status Report to Master so that status reports are sent to the Master MVP120.

Note: In a Dial-On-Demand (DOD) network, you should leave Send Status Report to Master disabled. This allows the router to disconnect whenever there is no voice activity. Note that Slaves with Send Status Report to Master disabled will show up as “Unknown” when viewing Slave status on the Master.

19.Click OK to return to the Main menu.

20.Click Download Setup to write the new configuration to the slave unit. The Save Setup dialog box displays.

21.Select the Save Current Setup as User Default Configuration check box and click OK. The Writing Setup dialog box displays as the setup configuration is written to the MVP120.

22.Check that the Boot LED on the MVP120 is off after the download is complete. This may take several minutes as the MVP120 reboots.

23.You are returned to the Main menu.

Your MVP120 is operational at this time. Repeat the process for each of the slave units. When all slaves have been configured, go to “Deploying the VOIP Network”.

Multi-Tech Systems, Inc. MultiVOIP User Guide 42