Multiplex Technology 301 Auxiliary function, servo, Erase, to return to the operating screen

9.3.	to return to the operating screen
This menu point is used to reset the model memory to the
factory default settings. These settings are:		ERASE
	Servo centre 0%, servo travels 100%
		ALL

§Use the 1 button to search for the menu point

ERASE ALL

§Confirm the erasure by holding the Gbutton pressed in for longer than 3 sec.

Press any menu button (except 1) to return to the operating screen.

10. Auxiliary function, servo 3

One special feature of the PROFI CAR 301 is that it can control a
third servo to provide an auxiliary function, e.g. for mixture
adjustment, two-speed gearbox etc. The auxiliary channel is
controlled by trim rocker 3.	3
Three different modes are available for auxiliary channel 3.

v3P 3 positions (left, centre, right)

v	FL	flashing
v	PR	proportional (25 increments)

The screen shows the position of the auxiliary channel. The default setting for the auxiliary channel is three-position mode.

You can adjust travel and centre for servo 3 in the menu point “S-TRAV” in the ” T“menu (è10.2).

This is how auxiliary channel 3 is used in its three modes:

§“3P” mode (3 Positions)

If you press the same end of rocker 3 repeatedly, the servo switches between centre and one end-point. If you press the other end of rocker 3, the servo immediately moves to the opposite end-point.

§“FL” mode (FLashing)

In flashing mode the servo switches automatically between centre and one of the two end-points every 0.5 sec. The flashing is switched on and off by pushing rocker 3.

§“PR” mode (PRoportional)

Every time you press rocker 3, the servo position changes by one increment. 25 increments are available.

In practice, the best way to find out how these modes of operation work is simply to try them out using a spare servo.

35