Multiquip 8FP Series manual Table of Contents

TABLE OF CONTENTS

MULTIQUIP FLOOR PLANERS 8FP SERIES

Table Of Contents		3-4
Parts Ordering Procedures		6
Notice to Operators		7-8
Operator Instructional Data Sheet		9
Safety Precautions		10
Preparation		11
Operation		12
Maintenance, Repair and Storage		13
Assembly		14
Removing the Floor Planer from the Pallet		14
Before Starting the Engine		14
Filling the 8FP/G Series Engine Crankcase with Oil		14
Filling the 8FP/G Series Engine Fuel Tank		15
Operation		15
Theory of Operation		15
Flail Design and Application		16-18
Spacers Washers		18
Flair Drum Rods		18-19
Flail Drum Design and Application		20
Installing Flails on the Two Section Drum		21-23
Installing a Loaded Drum On the Driveshaft		23-24
Transporting the Floor Planer		24
Starting the 8FP/E on the Jobsite		25-26
Starting the 8FP/G on the Jobsite		27
Operating the 8FP/E and 8FG/G Floor Planers on the Jobsite		27-31
Stopping the 8FP/E Floor Planer on the Jobsite		31
Stopping the 8FP/G Floor Planer on the Jobsite		31
Service		31
Preventative Maintenance Check List		31-32
Checking V-Belt Tension and Alignment		32
Installing a Replacement V-Belt or Pulley		33
Installing Replacement Bearing on the V-Belt Side		35-37
Installing Replacement Bearing on the Outboard Side		37-39
Lubrication Requirements		39
Aligning the Caster Wheels		40
Checking Driveshaft Runout		41
Engine Service		43
Troubleshooting		44
Electric Motor		44
Gasoline Engine		44
Operational Problems		44-45
8FP FLOOR PLANER-SERIES	OPERATION AND PARTS MANUAL REV #2 (05/28/09)	PAGE 3