Multiquip DCA-15SPX4 - OUTPUT TERMINAL PANEL FAMILIARIZATION, 120VAC GFCI Receptacle

DCA-15SPX4 — OUTPUT TERMINAL PANEL FAMILIARIZATION

120VAC GFCI Receptacle

This120VAC, 20 amp GFCI (Duplex Nema 5-20R) receptacle can be used anytime the generator is in operation. Remember the load output (current) of the GFCI receptacle is dependent on the load requirements of the U, N, and V output terminal lugs.

Pressing the reset button resets the GFCI receptacle after being tripped. Pressing the Test Button (See Figure 6) in the center of the receptacle will check the GFCI function. Both receptacles should be tested at least once a month.

L5-30RTwist Lock 120VAC Receptacle

There is one L5-30R, 120 VAC 30 amp auxilliary twist-lock receptacle (Figure 8) provided on the output terminal panel.

Figure 6. G.F.C.I. Receptacle

Twist Lock DualVoltage 120/240VAC Receptacle (Option)

There is one CS-6369 120/240V, 50 amp auxilliary twist-lock receptacle (Figure 7) provided on the output terminal panel. This receptacle is protected by a 50 amp circuit breaker.

CS-6369

TWIST-LOCK

RECEPTACLE

SINGLE-PHASE

120/240 VAC

50 AMP OUTPUT

Figure 7. 120/240V CS6369 Twist-Lock

Auxiliary Receptacle

Figure 8. 120 VAC L5-30R Twist-Lock

Auxiliary Receptacle

L6-30RTwist Lock 240VAC Receptacle (Option)

There is one L6-30R, 240 VAC 30 amp auxilliary twist-lock receptacle (Figure 9) provided on the output terminal panel.

Figure 9. 240 VAC L6-30R Twist-Lock

Auxiliary Receptacle

Turn the voltage regulator control knob (Figure 10) on the control panel to obtain the desired voltage.Turning the knob clockwise will increase the voltage, turning the knob counter- clockwise will decrease the voltage.

Figure 10. Voltage Regulator Control Knob

DCA-15SPX4— OPERATION MANUAL — REV. #0 (02/17/09) — PAGE 23