Multiquip operation manual DCA-15SPX4 Generator START-UP Procedure, Speed Control Switch RUN

DCA-15SPX4 — GENERATOR START-UP PROCEDURE

5. Set the Speed Control Switch to the RUN position	8. Place the main, GFCI, and aux. circuit breakers in the
(Figure 30).	ON position (Figure 34).

Figure 30. Speed Control Switch (RUN)

6.The ammeter (Figure 31) will indicate zero amps with no load applied.When a load is applied, the ammeter will indicate the amount of current that the load is drawing from the generator.

Figure 34. Main, GFCI, and Aux.

Circuit Breakers (ON)

9.Observe the generator's ammeter (Figure 35) and verify it reads the anticipated amount of current with respect to the load. The ammeter will only display a current reading if a load is in use.

Figure 31. Ammeter (No Load)

7.The generator's AC-voltmeter (Figure 32) will display the generator’s output in VOLTS. If the voltage is not within the specified tolerance, use the voltage adjustment control knob (Figure 33) to increase or decrease the desired voltage.

Figure 35. Ammeter (Load)

10.The generator will run until manually stopped or an abnormal condition occurs.

Figure 32. Voltmeter

Figure 33. Voltage Adjust Control Knob

PAGE 32 — DCA-15SPX4— OPERATION MANUAL — REV. #0 (02/17/09)