Multiquip DCA-180SSV operation manual Connecting Loads, Over Current Relay

DCA-180SSV— OUTPUT TERMINAL PANEL FAMILIARIZATION

Connecting Loads

Loads can be connected to the generator by the Ouput Terminal Lugs or the convienience receptacles (Figure 12). Make sure to read the operation manual before attempting to connect a load to the generator.

To protect the output terminals from overload, a 3-pole, 1000A main circuit breaker is provided. Make sure to switch ALL circuit breakers to the OFF position prior to starting the engine.

Over Current Relay

An over current relay (Figure 13) is connected to the main circuit breaker. In the event of an overload, both the circuit breaker and the over current relay may trip. If the circuit breaker can not be reset, the reset button on the over cur- rent relay must be pressed. The over current relay is lo- cated in the control box.

Figure 13. Over Current Relay

Figure 12. Connecting Loads

PAGE 26 — DCA-180SSV— OPERATION AND PARTS MANUAL — REV. #1 (04/14/10)