Multiquip DCA25USI manual Generator Shut-Down Procedures, Normal Shutdown Procedure

GENERATOR SHUT-DOWN PROCEDURES

WARNING

NEVER stop the engine suddenly except in an emergency.

Normal Shutdown Procedure

To shutdown the generator, use the following procedure:

1.Place both the MAIN, GFCI and LOAD circuit breakers as shown in Figure 50 to the OFF position..

Figure 50. Main, GFCI and Load

Circuit Breakers Off

2.Let the engine cool by running it at low speed for 3-5 minutes with no load applied.

3.Place the ignition switch (Figure 51) in the “STOP” position, remove the key and store in a safe place.

Figure 51. Ingition (Switch Normal)

4.Verify that all status LEDs on the MPEC display are OFF (not lit).

5.Remove all loads from the generator.

6.Inspect entire generator for any damage or loosening of components that may have occurred during operation.

Emergency Shutdown Procedure

1.Place the main,G.F.C.I.,and aux. circuit breakers (Figure 52) in the OFF position.

2.Turn the ignition key (Figure 52) to the STOP position.

Figure 52. Ingition Switch (Emergency)

page 34 — DCA25Usi 60 hz Generator • operation and parts manual — rev. #3 (07/19/11)