Multiquip gb43sc manual Lamp Safety and Care

GLOBUG 4-SPOT — RULES FOR SAFE OPERATION

■When transporting the GloBug 4-Spot, lower the mast fully. Tighten the lamp adjustment lever and make sure that the lighting unit assembly is fixed to the mast before transporting. This will prevent the light assembly from falling down or being damaged during transport.

LAMP SAFETY AND CARE

■NEVER leave any grease or oil residue on lamp surface when replacing or removing lamp. This can create hot spots, reducing the service life of the lamp.

■ALWAYS make sure the lamp surface is clean and dry.

■ALWAYS replace with MQ recommended type lamp. See parts section of this manual.

■NEVER use force when installing a lamp. Excessive force could cause the lamp to break causing bodily harm.

■NEVER attempt to replace lamp with the power on. Always unplug the power cord from the generator when changing the lamp.

■ALWAYS allow a sufficient amount of time for the lamp to cool before changing. The possibility exists of severe burns.

■ALWAYS have a trained technician to install and remove lamp, or replace any damaged fixture wiring.

DANGER - GloBug High Danger Areas

The DANGER items listed below and on the next page are considered High DANGER areas and should be adhered to. Failing to understand these areas could result in Bodily Harm, Electrical Shock, Electrocution, and even Death!

Please pay close attention when operating the lighting system.

DANGER - Grounding the GloBug for Operation

The GLOBUG 4-SPOT is equipped with a ground terminal for your protection. ALWAYS complete the grounding path from the lighting system to an external grounding source.

ALWAYS make certain the GloBug is well grounded and securely fastened to a good earth ground (ground rod).The possibility exists of Electrical Shock, Electrocution, and even Death if the GloBug is not grounded.

PAGE 10 — GLOBUG 4-SPOT — OPERATION AND PARTS MANUAL — REV. #3 (12/15/08)