Multiquip gb43sc manual GLOBUG 4-SPOT - COMPONENTS

Figure 6 shows the location of the controls and components for the GLOBUG 4-SPOT. The functions of each control is described below:

1.Reflex Mirror – Enhances lighting from the bulbs.

2.Lighting Unit – Consists of 4 lamps in their sockets.

3.Lamp Stand – holds the four lamps of the lighting unit together.

4Lamp – 400 watt metal-halide type lamp. Replace with only MQ recommended type lamp. Always allow a sufficient amount of time for the lamp to cool down before changing.

5.Adjust Lever – This lever allows the lamp to be positioned up or down.Turn counterclockwise to release lamp and position. Turn clockwise to tighten.

6.Fold Lever – Holds the lamp stand in place after adjusting its height.

7.Lamp Power Cable – Connects the lamps to the power (generator).

8.Mast – This mast is comprised of three separate stages. The mast can be raised in excess of 13.78 feet. (4.2 meters). Again when raising the mast, always be on the lookout for overhead obstructions.

9.MastWinch – Use this winch to raise and lower the mast. Always be on the lookout for overhead obstructions. Keep immediate area free of bystanders and debris when raising the mast.

10.Winch Handle– Use this handle to adjust the mast height.

11.Lift Hanger – When lifting of theGloBug is required always use a suitable lifting device of adequate lifting capability. NEVER stand underneath the GloBug while it is being lifted.

12.Steering Handle – The GloBug can be moved in either a forward or reverse direction by pulling back or pushing forward on the T-handle. In addition the front wheels are designed to turn in the opposite direction of theT-handle placement thus allowing the GloBug to turn either left or right.

13.Counterweight Lever – Holds the outriggers in place when deployed.

GLOBUG 4-SPOT — COMPONENTS

14.Locking Clamps – To secure the generator to the GloBug cart platform, place clamps (4) around the pipe frame of the generator. Tighten securely to prevent movement.

15.Outriggers – ALWAYS deploy the outriggers when raising the mast.

16.Guide Square Pipe - frames the generator.

17.Brake Pedal – Step on this pedal to apply the brakes.To release the brakes, press down on brake pedal again.

18.Cart – Holds the generator that supplies power to the lighting unit.

19.Tires – The GloBug 4-Spot uses 4 pneumatic type tires. Replacewithonlyrecommendedtype tire. NEVERallow the rear tires to go flat. This could adversely affect the braking system. Inflate tires to 35.5 psi (245kPa).

20.Catcher – Holds the outrigger in place in the stow position.

21.Brake Pad – When the brake pedal is pressed, this pad will strike and hold the rear tires in place. Make sure rear tires are inflated to the correct air pressure.

GLOBUG 4-SPOT — OPERATION AND PARTS MANUAL — REV. #3 (12/15/08) — PAGE 17