Multiquip gb43sc manual GLOBUG 4-SPOT - OPERATION, Applying Power, Caution - Read Generator Manual

DANGER - HIGH VOLTAGE POWER LINES

When raising mast, ALWAYS be on the lookout for overhead obstructions such as high voltage power lines.The possibility exists of electrocution, even death, if the GloBug comes in contact with high voltage power lines.

Applying Power

1.Make sure the generator lamp switch (Figure 19) is in the OFF position.

STARTER KEY

GENERATOR

LAMP SWITCH

Figure 19. GeneratorLamp Switch

CAUTION - READ GENERATOR MANUAL

Before attempting to operate the generator, READ the entire operation section of the manual. Failure to read manual could cause severe damage to the equipment and bodily harm to the operator.

2.The GloBug has a power requirement of 120 VAC, 60 Hz @ 18 amps. Connect the GloBug 4-Spot AC power cord to the 120 VAC twist-lock receptacle (Figure 20) on the

GLOBUG 4-SPOT — OPERATION

3.Start the generator as referenced in the "Start-up Section" of the supplied generator manual.

4.Leave the engine idling for about 3 minutes to warm it up.

5.Place the generator lamp switch (Figure 19) to the ON position.

6.The lamp should light up and give a fully bright light in about 5 minutes. If the lamp is not on, check all connections and repeat steps 1 through 5. If the lamp still does not come on contact the MQ service department.

Shutdown

1.Place the generator lamp switch (Figure 19) to the OFF position.

2.Disconnect the GloBug 4-Spot AC power cable from the generator.

3.Shutdown generator as referenced in the "Shutdown Section" of the supplied generator manual.

CAUTION - LAMP COOL DOWN

Allow a sufficient amount of time (15-20 minutes) for the lamp to cool down before turning on lighting unit again. Do not touch lamp before cooling down. Lamp surface is very hot and can cause burns (Figure 21).

CAUTION - GENERATOR DAMAGE

DON NOT shut down generator engine with the lamp switch on. This could cause damage or break the generator.

the supplied generator.

120 VAC

TWIST-LOCK RECEPTACLE

20A

GLOBUG 4-SPOT

POWER CABLE

120V

TYPICAL

GENERATOR

FRONT PANEL

Figure 21. Hot Lamp Surface

Figure 20. 120 VAC Receptacle

GLOBUG 4-SPOT — OPERATION AND PARTS MANUAL — REV. #3 (12/15/08) — PAGE 21