Multiquip gb43sc manual GLOBUG 4-SPOT - NAMEPLATE AND DECALS, Ballast Box, Danger, High Voltage

GLOBUG 4-SPOT — NAMEPLATE AND DECALS

NAMEPLATE AND DECALS 4

DANGER

ELECTRICAL

SHOCK HAZARD

When replacing lamp and to prevent electrical shock, ALWAYS shutdown the generator before replacing lamp. Remember to let lamp cool before removing. Use only recommended type lamp as

listed in parts manual. DCL416

	DANGER
	ELECTRICAL
	SHOCK HAZARD
21	NEVER touch a live power cord
	or active electrical components
	with wet hands or while standing
	in water. The possibility of electrical
	shock or even death! exists.
	DCL410

	CAUTION
	LAMP INFORMATION
11	ALWAYS turn lamp OFF
	first, before shutting down
	generator.

Once lamp is turned OFF, Allow lamp to cool down before turning back on. It will take about 20 minutes

WARNING

BURN HAZARD

To prevent burns, NEVER touch lamp while lamp is on. Lamp surface gets extremely hot! ALWAYS allow sufficient time for lamp to cool down

before touching.

DCL417

5

12

WARNING

3

before lamp can be turned back on.

DCL409

6	CAUTION
	When the GloBug is used for
	non-lighting applications, ALWAYS
	un-plug GloBug AC power cord
	from the generator.
	DCL402

7

8

DANGER

WARNING

When lifting of the GloBug is required, ALWAYS attach a rope or chain to the lift hanger. DO NOT use any other lifting points to lift the GloBug.

	LIFT
	HANGER
		DCL412
13
DANGER
GlowBug
INFORMATION
To prevent tipping, NEVER use		14
in winds that exceed 22 mph
(10 m/sec).
NEVER use on an incline of 5
degrees or more. The possibility
of tipping exists.
NEVER use in rain or wet
conditions. The possibility of
electrocution exists.
ALWAYS apply parking brake
to prevent moving.
When moving is required, lower
mast fully.
When raising mast, ALWAYS
deploy outriggers to prevent
tipping.
ALWAYS turn OFF generator
before performing maintenance.
	DCL411

15

DANGER

ELECTRICAL

SHOCK HAZARD

NEVER place the GloBug wheels in standing water. The possibility of electrical shock, even death! Exists.

10

DCL400

	WARNING
20	BURN HAZARD
	To prevent burns, NEVER
	touch ballast or cover while
	lamp is on. These surfaces are
	extremely hot! ALWAYS allow
	sufficient time for both surfaces
	to cool down before touching.
	DCL415

WARNING

To avoid injury,

you MUST read

and understand

operator’s manual

before using this

machine.

This machine to

be operated by

qualified

personnel only.

Ask for training

as needed.

18

MODEL SERIAL NO.

19

CAUTION

TIRE PRESSURE

ALWAYS keep tires inflated to correct pressure. Low or incorrect tire pressure could result in brake malfunction.

Recommended tire pressure:

35.5 PSI

(225 kPa)

DCL407

9

DANGERELECTRICAL

SHOCK HAZARD

GROUND

To prevent electrical shock or electrocution, the generator MUST be connected to an earth ground. (See NEC Article 250)

DCL405

WARNING

OUTRIGGER

DEPLOYMENT16

SETTING:

Pull outrigger upward at the tip end and rotate backwards until it locks in place.

STOW

POSITION

DEPLOYEDOUTRIGGERS

RELEASE:

To unlock outrigger, push downward on the counter-weight lever indicated by arrow. Grab hold of outrigger, pull upward, push down and place in stow position.

DCL414

BALLAST

BOX

17

HIGH VOLTAGE	DANGER
	DCL418

PAGE 32 — GLOBUG 4-SPOT — OPERATION AND PARTS MANUAL — REV. #3 (12/15/08)