Multiquip manual LS400/LS500 Pump Inspection, Engine OIL Check, Hydraulic OIL Check

ENGINE OIL CHECK

1.Remove the engine oil dipstick from its holder (Figure 10).

Figure 10. Engine Oil Dipstick

2.Make sure pump/engine is placed on level ground.

3.Pull the engine oil dipstick (Figure 11) from its holder.

LS400/LS500 PUMP — INSPECTION

6.The oil listed inTable 4 is recommended to ensure better engine performance. Use class CD or higher grade motor oil.

HYDRAULIC OIL CHECK

1.Determine if the hydraulic oil level is low by observing the level of the oil in the Hydraulic Oil Sight Glass (Figure 12).

NORMAL OIL LEVEL

HYDRAULIC OIL TEMPERATURE

MINIMUM OIL LEVEL

Figure 11. Engine Oil Level Figure 12. Hydraulic Oil Sight Glass

4.Verify that oil level (Figure 11) is maintained between the two notches on the dipstick.

5.If the pump's engine oil is low, fill engine crankcase with lubricating oil through filler hole, but DO NOT overfill.

PAGE 24 — MAYCO LS400/LS500 PUMP — OPERATION AND PARTS MANUAL — REV. #6 (09/19/11)