Multiquip manual LS400/LS500 PUMP - OPERATION, Cable Remote Control, Warning -Transporting Pump

Radio Remote Control Programming

Before starting operation of the Radio Remote Control, go to Screen 9 of the Digital Readout Screen:

RADIO ADDRESS 9

NO RADIO

PRESS RESET TO

LEARN A NEW ONE

1.Press the ON/OFF button on the radio (wireless) remote control to turn on the power. Hold down the RESET switch. The display will now show:

RADIO ADDRESS 9

NOW SCANNING

FOR NEW

TRANSMITTER

2.After 5 seconds, the display will show:

RADIO ADDRESS 9

COMMUNICATING

PRESS RESET TO

LEARN A NEW ONE

3. The remote control is now ready for use.

Cable Remote Control

Installation of the Cable Remote Control Assembly

Connect the cable to the front panel of the control box (See Figure 38).

LS400/LS500 PUMP — OPERATION

Cable Remote Control Operation

Before using cable remote control, set the pumping volume with the VOLUME switch on the control box then move the Pumping Control Switch on the control box to the REMOTE position.

The cable remote control (Figure 38) has the following controls.

PUMP ON/OFF - Starts and stops the forward pumping.

PUMP REV - starts pumping in reverse direction.

WARNING -TRANSPORTING PUMP

It will be necessary at times to move your pump from one job site location to another. Before moving the pump, make sure to pump the remaining concrete out of the hopper. Moving the pump with a full hopper of concrete can cause severe damage or breakage of the axle and axle springs, excess strain and pressure on the hub and bearing assembly.

Leaking manifold seals or hose coupling gaskets which leak water can cause separa- tion and subsequent jamming at that point.

CABLE REMOTE CONTROL UNIT

25 FT. CABLE

PUMP REV

PUMP ON/OFF

TO CONTROL BOX

CONNECTOR

Figure 38. Cable Remote Control

MAYCO LS400/LS500 PUMP — OPERATION AND PARTS MANUAL — REV. #6 (09/19/11) — PAGE 31