Multiquip manual LS400/LS500 PUMP - INSPECTION, Fuel Check, Before Starting, Fuel Cap Gauge

CAUTION - GENERAL SAFETY GUIDELINES

NEVER operate the pump in a confined area or enclosed area structure that does not provide ample free flow of air.

ALWAYS wear approved eye and hearing protection before operating the pump .

NEVER operate the pumps's engine with the engine hood removed. The possibility exists of hands, long hair, and clothing becoming entangled with the V-belt, causing injury and bodily harm.

NEVER place hands or feet inside the hopper. ALWAYS make while the engine is running. ALWAYS shut down the engine before performing any kind of maintenance service on the pump.

See Figures 5, 6, and 7 for the location of any control or component referenced in this section.

LS400/LS500 PUMP — INSPECTION

FUEL CHECK

1.Check the fuel gauge built into the fuel tank cap (Figure 8) to determine if the pump's engine fuel is low. Refuel as needed.

WARNING - EXPLOSIVE FUEL

Diesel fuel is extremely flammable, and its vapors can cause an explosion if ignited. DO NOT start the engine near spilled fuel or combustible fluids. DO NOT fill the fuel tank while the engine is running or hot.

DO NOT overfill tank, since spilled fuel could ignite if it comes into contact with hot engine parts or sparks from the ignition system. Store fuel in approved containers, in well-ventilated areas and away from sparks and flames. NEVER use fuel as a cleaning agent.

BEFORE STARTING

1.Read safety instructions at the beginning of manual.

2.Clean the entire pump, removing dirt and dust, particu- larly the engine cooling air inlet, and heat exchanger.

3.Check the air filter for dirt and dust. If air filter is dirty, replace air filter with a new one as required.

4.Check fastening nuts and bolts for tightness.

WARNING - EXPLOSIVE FUEL

Handle fuel safely. Diesel fuel is highly flammable and can be dangerous if mishandled. DO NOT smoke while refueling. DO NOT attempt to refuel pump if the engine is hot or running.ALWAYS allow engine to cool before refueling.

Figure 8. Fuel Cap Gauge

2.If fuel is low, remove fuel filler cap and fill with #2 diesel fuel (Figure 9).

Figure 9. Adding Diesel Fuel

MAYCO LS400/LS500 PUMP — OPERATION AND PARTS MANUAL — REV. #6 (09/19/11) — PAGE 23