SAFETY INFORMATION
TRANSPORTING SAFETY
CAUTION
Before lifting, make sure that light tower parts are not damaged and screws are not loosened or lost.
ALWAYS make sure crane or lifting device has been properly secured to lifting hook of the equipment.
NEVER lift the equipment while engine is running.
Make sure the tower is in the stowed position before lifting.
STOWED
POSITION
Use adequate lifting cable (wire or rope) of sufficient strength.
Use one point suspension hook and lift straight upwards.
LIFTING BALE
LIGHT TOWER
FORKLIFT
POCKETS
If lifting through pockets, make sure forks of forklift are inserted in pockets as far as possible before lifting.
Never allow any person or animal to stand underneath the equipment while lifting.
DO NOT lift equipment to unnecessary heights.
Loading and Tie-Down on Flatbed Truck
NOTICE
Before loading light tower to flatbed truck, disconnect all four floodlight connectors and
CABLE
TIE
CABLE
CONNECTORS
DISCONNECTED
When loading onto flatbed truck, make sure that front jackstand of light tower is retracted and in the horizontal position so that the foot does not make contact with the deck floor.
FRONT JACKSTAND
RETRACTED
TONGUE | TRANSPORT | |
| ||
| POINT (4) |
SIDE | REAR |
JACK | JACK |
STAND (2) | STAND (2) |
Make sure that the two side (left and right) and two rear jackstands are in the vertical postion, slightly extended, so that each foot makes contact with the deck floor.
Straps and chains should be routed through the transport
DO NOT secure the unit by running a strap or chain over the tongue of the light tower. This may cause severe damage to the unit.
PAGE 10 — LT12 SERIES LIGHT TOWER • OPERATION MANUAL — REV. #12 (01/20/09)
