Multiquip PS706036 PS7060 Multiquip SAW RAISE-LOWER Controls, Top View Raise Lower Controls

PS7060 MULTIQUIP SAW — RAISE-LOWER CONTROLS

2.Using 10-12 ft. (3-3.7 meters) of stringline, divide the length of the string in half and slide the string into one of the slots or gullets on the backside of the blade, (as viewed standing in front of the pointer). (Item 2, Figure 28) Hold both ends of the string in one hand and pull the string taut. (Item 3) Move your hand from side to side until both strings are touching both sides of the blade.

3. Adjust the pointer rod (Item 5), by loosening the lock knob (Item 4). Move the pointer directly over the middle of the two strings in your hand and tighten the pointer setscrew to lock the pointer in position. Repeat this process for the rear pointer.

4.To raise the front pointer assembly, (Item 1) first pull back and up on the pointer cable. Secure the pointer assembly in the desired raised position by locking the cable between the jaws of the cam cleat.

2

1

5

4

Top View

3

Raise - Lower Controls

The PS7060 saw uses a 12-volt hydraulic pump and cylinder to raise and lower the saw. The raise-lower function is controlled by the operator through a 3-position toggle switch on the raise- lower control handle located on the operators control panel.

Figure 29. Raise-Lower Control Toggle Switch

1.To Lower the blade, push the toggle switch located on the end of the Control Handle FORWARD, ( Figure 29).

2. To Raise the blade, pull the toggle switch located on the end of the Control Handle BACKWARD.

Setting the Depth Indicator

1.Lower the blade until it just touches the cutting surface.

2. Set the Depth Indicator dial to zero. (The Depth Indicator now accurately indicates how deep the blade is cutting.) (Figure 30)

Figure 28. Adjusting the Pointer Assembly Figure 30. Depth Indicator

PAGE 34 — PS7060 MULTIQUIP SAW • OPERATION MANUAL — REV. #2 (06/02/08)