Multiquip PS706016, PS706026 PS706030, PS706020 PS7060 Multiquip SAW Bladeshaft Engage System

PS7060 MULTIQUIP SAW — BLADESHAFT ENGAGE SYSTEM

Depth Control System

The PS7060 saw uses an electronically controlled Depth Stop to position and lock the blade at the desired cut depth.

To Control the Depth of Cut with saw running and Blade Mounted:

1.Raise the saw above the desired cutting depth.

2. Turn the Depth Control Knob counterclockwise until the saw cannot be lowered by pushing the Raise/Lower Switch forward. (Figure 31.)

1

Raises

Lowers

2

To Re-adjust for Full Cutting Depth:

1.Hold the Raise/Lower Switch in the Lowering position and rotate the Depth Control Knob clockwise until the saw is fully lowered.

2. Rotate Depth Control Knob clockwise an additional 1 turn.

To disable the Depth Stop when it is not needed:

1.While holding the Raise-Lower toggle switch FORWARD, rotate Depth Control Knob CLOCKWISE until saw is at full depth position.

2. Rotate Depth Control Knob an additional 1-2 turns.

Bladeshaft Rotation Dis-engagement System

The engine MUST be at IDLE when engaging or dis-engaging Bladeshaft Drive. (Item 1, Figure 32.)

1

		6
4
	5	Depth Control Knob
3	1.
	2.	Raise/Lower Toggle Switch
	3.	Adjuster Bracket
	4.	Adjuster Cable/Spring assy.
	5.	Adjuster Nut
	6.	Depth Control Housing

Figure 31. Setting Depth Gauge and Depth

Stop

To STOP Bladeshaft Rotation:

Push rocker switch labeled BLADESHAFT forward, (Item 2, Figure 32). Engine will tilt forward, disengaging the belt drive.

To START Bladeshaft Rotation:

Push rocker switch labeled BLADESHAFT backward, (Item 2, Figure 32). Engine will tilt back, engaging belt drive.

2

1

3. Hold the Raise/Lower Switch in the Lowering position and
rotate the Depth Control Knob clockwise until desired
cutting depth is achieved. The saw will repeat to the same
depth until readjusted.	Figure 32. Bladeshaft Engage/Dis-engage

2. Turn the depth control knob counterclockwise until the saw cannot be lowered by pushing the raise/lower switch forward.

PS7060 MULTIQUIP SAW • OPERATION MANUAL — REV. #2 (06/02/08) — PAGE 35