Multiquip operation manual TLG-12SPX Shutdown Procedure, Engine Shutdown

TLG-12SPX — SHUTDOWN PROCEDURE

5.The generator's frequency meter (Figure 23) displays the 60 cycle output frequency in HERTZ.

8.Set the circuit breaker to “ON”. Observe the generator's ammeter (Figure 27) and verify it reads the anticipated amount of current with respect to the load.The ammeter will only display a current reading if the load is in use.

40

2060

075

A

Figure 23. Frequency Meter (Hz) Figure 27. Ammeter (Load)

6.The generator's voltage meter (Figure 24) displays the 120 VAC in VOLTS. If the voltage is not within the specified frequency tolerance, use the voltage adjustment control knob (Figure 25) to increase or decrease the desired voltage.

Figure 24. Voltage Meter (Volts)

Figure 25. Voltage Adjust Control Knob

9.The generator will run until manually stopped or an abnormal condition occurs.

ENGINE SHUTDOWN

To shutdown the generator, use the following procedure:

1.Turn off all equipment attached to generator. Switch the Circuit Breaker to ‘OFF’ .

2.Turn the throttle handle to the left and push in.

3.Let the engine cool by running it for 3-5 minutes with no load applied.

4.Turn the key to ‘STOP’ position and remove the key.

7.The ammeter (Figure 26) will indicate zero amps with no load applied. When a load is applied, this meter will indicate the amount of current that the load is drawing from the generator’s alternator.

40

2060

075

A

Figure 26. Ammeter (No Load)

PAGE 38 — TLG-12SPX — PARTS AND OPERATION MANUAL (STD) — REV. #4 (03/08/05)