Multiquip WM70SH5C, WM70SH8C manual Inspection, Before Starting, Engine Oil Check

inspection

Before Starting

1.Read all safety instructions at the beginning of manual.

2.Clean the unit, removing dirt and dust, particularly the engine cooling air inlet, carburetor and air cleaner.

3.Check the air filter for dirt and dust. If air filter is dirty, replace air filter with a new one as required.

4.Check carburetor for external dirt and dust. Clean with dry compressed air.

5.Check fastening nuts and bolts for tightness.

CAUTION

ALWAYS wear approved eye and hearing protection while operating the mixer.

CAUTION

NEVER place hands or feet inside the engine guard cover while the engine is running. ALWAYS shut the engine down before performing any kind of maintenance service on the mixer.

Engine Oil Check

1.To check the engine oil level, place the unit on secure level ground with the engine stopped.

2.Remove the filler dipstick from the engine oil filler hole (Figure 5) and wipe it clean.

Figure 5. Engine Oil Dipstick (Removal)

3.Insert and remove the dipstick without screwing it into the filler neck. Check the oil level shown on the dipstick.

4.If the oil level is low (Figure 6), fill to the edge of the oil filler hole with the recommended oil type (Table 5). Maximum oil capacity is 2.33 pints (1.09 liters).

NOTICE

Reference engine manufacturer’s manual for specific servicing instructions.

UPPER LIMIT

LOWER LIMIT

Figure 6. Engine Oil Dipstick (Oil Level)

Table 5. Oil Type

Season	Temperature	oil Type
Summer	25°C or Higher	SAE 10W-30
Spring/Fall	25°C ~ 10°C	SAE 10W-30/20
Winter	0°C or Lower	SAE 10W-10

page 16 — WM70SH5C/wm70sh8c Mixer • operation and parts manual — rev. #0 (06/07/11)