25
4BIIS OPERATION
DDDirect code entryqWhile in the standby condition, push [TX Code Enter] to enter
the TX code edit mode.
•Editable code digit blinks.
wPush [TX Code Enter] to select the desired digit to be edited.
•Editable digit differs according to the setting.
eSet the desired digit using [ ]/[ ]/[TX Code CH Up]/[TX
Code CH Down].
rPush [TX Code Enter] to set the digit. The editable digit will move
to the right automatically.
tRepeat eand rto input all allowable digits.
yPush [P0] (Call) or [PTT]* to call.
*PTTcall can be made only when PTT call capability is permitted.
NOTE:When no answer back is received, the transceiver re-
peats the call 3 times (default) automatically, and “”is
displayed during each call. However, an error beep sounds
and “”is displayed when no answer back is received
after the calls.
uPush [PTT] to transmit; release to receive.
iPush [P3] (Moni(Audi)) to send the “Clear down” signal.
For your information
When the “UpDate” setting for the call code is enabled, the set code
is overwritten into the call code memory.
IC-F50_F60_MDC-2.qxd 06.11.17 4:39 PM Page 25 (1,1)