Mustang Survival MD0450 manual Inserting the MA1900 Sailing Harness

Models: MD0450

1 42
Download 42 pages 36.03 Kb
Page 26
Image 26

The harness is to be worn by individuals that are at least 5 feet 5 inches tall. The harness should be worn as high on the chest as possible. However, in all cases, the belt should be worn at least 2 inches above the lowest rib measured from the bottom of the belt and should not be used if it does not fit in this manner. Adjust the harness by donning the harness and using the sliders so that it is as snug as tolerable. Failure to adjust the harness properly could result in injury. The harness may now be inserted into the Inflatable Vest with LIFTTM (MD0450 only, see INSERTING THE MA1900 SAILING HARNESS, p. 22).

When attached to the boat; use a tether of less than 6 feet 6 inches in length with quick-release under-load hardware.

Ensure that a tether, if used, is secured to both harness rings (MD0450 only).

WARNING: Use of a sailing harness to prevent falls overboard presents several risks. In case of capsizing or sinking, the boat may take you down. As such, ensure that any tether used has quick-release under-load hardware. This harness has not been designed for fall arrest, lifting or climbing and should not be relied upon in any of these instances.

US Coast Guard approval does not apply to this harness and the potential for injury has not been assessed.

INSERTING THE MA1900 SAILING HARNESS

Use this section if you are using a MA1900 Sailing Harness with the Inflatable Vest with LIFTTM (Model MD0450 only).

1)Put the MA1900 Sailing Harness on as you would a vest, and fasten and adjust the belt to fit (see Adjusting the MA1900 Sailing Harness, p. 27). The label should be facing towards the body (not visible).

23

MUSTANG SURVIVAL

Page 26
Image 26
Mustang Survival MD0450 manual Inserting the MA1900 Sailing Harness