L36 LOUVRE INSTALLATION
25
END DOOR INSTALLATION
FIGURE 54 | A |
|
|
B
C
Ensure that the door is properly clipped onto the steel lip to pre- vent overheat- ing, glass break- age and / or dis- colouration of the upper trim.
FIGURE 56
FIGURE 55
STEEL LIP
DOOR
To install the door(s), hook it over the steel lip located above the door opening.
A CLIPS
FLANGE
CENTRE
SLOT
SLOT
TAB
HOOD
Attach the hood by pressing the top flange into the clips along the top of the louvre opening. Secure using a screw through the centre slot.
UPPER LOUVRES
Insert the louvre tabs into the slots located at the top left and right corners of the unit.
Secure with screws along the bottom of the door. Tighten screws snugly. Do not
FIGURE 57
B
C |
| LOWER LOUVRES | |
HINGE |
| Insert the hinge clips into the | |
SLOT | |||
CLIP | |||
| slots located at the bottom left | ||
|
| ||
|
| and right corners of the unit. | |
|
| To remove the louvres, pull the | |
|
| back tabs of the clips forward, | |
|
| while pushing the louvre assem- | |
|
| bly back. Lift the clip. |