ACCENT GLASS INSTALLATION
Carefully sprinkle the accent glass onto the glass support evenly. Ensure no glass falls into the burner area. If this happens, insert a clean bag into your vacuum cleaner and BURNER vacuum out the accent glass. Replacement accent glass
can be purchased from your authorized dealer.
FIGURE 16
11
ACCENT
GLASS
GLASS SUPPORT
LK8 LIGHT INSTALLATION (OPTIONAL)
1. Turn off the electrical and gas supply to the appliance.
2. Remove the frame from the unit by removing the the 2 stainless steel hex head securing screws from the bottom and lifting the frame off of the top trim bracket.
3. Lay the frame down on its front, being careful not to scratch the finish.
4. Starting at the top of the frame, take one light assembly and carefully snap it into place in the hole provided. Repeat for each of the light assemblies. The wires on the top 2 light assemblies will need to be fed in behind the heat shields.
Note: When installing the light kit be careful not to scratch your fingers on any of the exposed screws in the frame.
5.Connect the light assemblies to the appropriate flags on the wire harness. The wire harness is labeled (TR) top right, (BR) bottom right (TL) Top left and (BL) bottom left.
6.Secure the wires into the clips at both sides and the bottom of the frame. Use the extra clips provided to retain any loose wires.
7.
8. Open the control panel door, leave the wires connected to the ON/OFF switch and place the transformer into the bottom of the unit. Plug the transformer into the receptacle.
9.Attach one of the wire leads from the transformer to the lead on the wire harness labeled “TRANS”, and the other to the ON/OFF switch. Attach the last lead on the wire harness labeled “SWI” to the ON/OFF switch.
10.Close the control panel door.
11.Turn on the gas supply and electrical power.
TL | TR |
BL | BR |
| CLIPS X 5 |
FIGURE 17