Napoleon Fireplaces GSST8N, GSST8P manual Rain Tabs, Door Removal, Glass Removal

9

RAIN TABS

When shipped, the rain tabs should be at a 90º angle. Push the rain tabs down until they are at an approximate 60º angle to assist rain in running off and out of the unit.

90º

60º

RAIN
TAB	FIGURE 8

				LANGE	FIGURE 9
			F
			R
			O
			O
		P	D
T	O

					E
				R	R T
						A	I
			O
		O					N	E
		D						R
		M
		O
	T
O	T
B

DOOR REMOVAL

The door is held in place at the bottom by a retainer tab that inserts into a slot in the bottom edge of the door, and at the top with a tab that secures in the same fashion. The door is removed by lifting it off the tabs. When replacing, guide the door over the upper tab first, then over the lower tab.

SECURING THE DOOR IN PLACE

When shipped, the door is secured with two hitch pins along the top edge, replacing them is optional.

To secure the door in place use the supplied hitch pins as illustrated.

HITCH PIN

FIGURE 10

GLASS REMOVAL

Having removed the door, lay on a smooth flat surface, face down. There are 4 glass retainers that need to be bent away from the glass to release it from the frame. Do not pry on the glass.

When replacing DO NOT SUBSTITUTE MATERIAL, replace the gasket (W562-0008) and the glass (W300-0110). Set new glass into the frame and gently bend tabs into the gasket to secure.

*Ensure that the gasketed end of the glass is placed into the top of the door frame.

NOTE: Care must be taken when removing and disposing of any broken glass or damaged components. Be sure to vacuum up any broken glass from inside the appliance before operation.

GASKET*

GLASS

TOP

GLASS

RETAINERS

FIGURE 11

W415-0689 / 06.25.08