8
FINISHING
TMCSS MOUNTING CABINET INSTALLATION
!WARNING
Before starting the installation remove the | 1 | INSTALLATION | |
protective layer from all three components that | |||
TEMPLATE | |||
make up the GSST8 (cabinet, frame, and Torch) |
| ||
|
|
NOTE: It is recommended that all fasteners be stainless steel.
1. Using the installation template
2. Remove the template. Depending on the surface and fasteners, drill the appropriate holes. Hold the Torch up, aligning the mounting brackets to the mounting holes. Secure the Torch to the wall using the appropriate fasteners. NOTE: The Torch has been designed to have a 1/2” clearance between the rear outer panel and the mounting surface.
3. Start the fasteners into each of the six remaining | TORCH | |
| ||
mounting holes. Align the keyholes of the frame to the |
| |
heads of the fasteners and slide the frame down onto the |
| |
fasteners. Ensure the frame is plumb and level before | MOUNTING | |
tightening the fasteners. NOTE: It is recommended that | ||
FRAME | ||
the gas and electrical be connected to the appliance | ||
| ||
at this stage. Both must enter the appliance at the |
| |
opening created between the bottom of the Torch | CABINET | |
and the bottom of the mounting frame. |
4.Slide the front of the cabinet over the mounting
frame, ensuring the “mesh” is to the top. Start each of | FIGURE 6 | 4 | |
the four screws (supplied) through the slots. | Once the |
| |
cabinet has been adjusted for depth the |
| 3 |
|
four screws can be tightened. |
|
| |
|
|
| |
2 |
MOUNTING BRACKET
KEYHOLE 
