Napoleon Grills BGD38NT, BGD38PT manual Optional FAN Installation, GD36 Thermostatic Sensor Control

FIGURE 47

21

OPTIONAL FAN INSTALLATION

ELECTRICAL INSTALLATION TO BE DONE BY A QUALI- FIED INSTALLER and must be connected and grounded in accordance with local codes. In the absence of local codes, use the current CSA C22.1 CANADIAN ELECTRICAL CODE in Canada or the ANSI/NFPA 70 NATIONAL ELECTRICAL CODE in the United States.

To safely install the fan, turn off the electricity first.

OPTIONAL THERMOSTATIC

SENSOR

RECEPTACLE /

JUNCTION BOX

VARIABLE SPEED/

PIEZO IGNITOR

BRACKET

OPEN ENDED

SLOTS

FIGURE 46

If the fireplace was not previously equipped with a fan: route a grounded 2-wire, 60hz power cable to the junction box. At this point, it must be strain relieved and insulated.

The wire harness provided in this kit is a universal har- ness. When installed, ensure that any excess wire is con- tained, preventing it from making contact with moving or hot objects.

To ease installation of the fan, remove the hinge screen and valve control door (lower lou- vres) from the base of the fire- place.

Position the vibration reducing pad into the clip and onto the threaded stud at the other end, piercing a hole into the pad. The

fan assembly must be able to be positioned entirely onto the pad.

Slide the fan assembly past the controls and into the clip. Secure using the lock washer and nut provided.

Plug the harness cord into the receptacle.

GD36 THERMOSTATIC SENSOR CONTROL

This optional kit is meant to be used only in conjunction with the GD65 Fan Kit, shown above, which may be or- dered from your Wolf Steel / Napoleon dealer.

With the thermostatic sensor option, the fan, when turned on, becomes thermally activated, and will automatically run approximately 15-30 minutes after the fireplace has been lit and for approximately 30-45 minutes after the fireplace has been turned off.

	THERMODISC
	SENSOR ASSEMBLY
	BRACKET
FIGURE 48	RECEPTACLE /
	JUNCTION BOX

Use of the fan increases the output of heat.

Unplug the power cord from the receptacle. Connect all wires as shown.

Attach and secure the sensor assembly bracket to the se- curing stud located next to the receptacle/junction box at the bottom left of the unit using the lock washer and wing nut. Ensure that the thermodisc touches the firebox wall.

Plug the power cord back into the receptacle.

When installed, ensure that any excess wire is contained, preventing it from making contact with moving or hot ob- jects.

FIGURE 49

W415-0244 / A / 05.15.03