Using the MH 110 Wireless Telephone |
Step 2 Slide the lip of the Battery Pack into the bottom of the cavity.
Step 3 Push the top of the Battery Pack until it snaps into place.
You should not have to force the Battery Pack into the Wireless Telephone.
NOTE
Changing the Battery Pack During a Call
The Battery Pack may be changed while a call is still in progress. Use the following steps to remove and replace the battery pack while in a call.
NOTE
If you are using the Telephony Gateway in your telephone system, do not press Power Off/End Call on the Wireless Telephone before beginning the following steps.
Step 1 Quickly remove the discharged Battery Pack and replace with a charged Battery Pack.
Refer to “Removing and Replacing the Battery Packs” on page
REFERENCE
Step 2 Press Power On/Start Call to turn the Wireless Telephone back on.
Step 3 Press Power On/Start Call again to resume the call in progress.
Users of IP telephony interfaces not requiring the UNIVERGE WL System Telephony Gateway should Park a call prior to changing the Battery Pack during an active call. The call should then be retrieved after the Battery Pack is replaced to rejoin the conversation.
Check with the switch administrator for instruction on how to perform this or a similar process on your particular telephone system.
REFERENCE
Mobile Handset 110 Wireless Telephone and Desktop Charger User Guide - Revision 1
