Preparing the Printer
1.Turn off the printer, remove the power cord from the rear of the printer, and disconnect the printer cable from the port (A). Position the printer so you are facing the side and back corner where the cable port is located. Make sure that you have enough room to work.
2.Using a small
3.Remove the screw that holds the small 1.5” x 3.75” plate over the Network Slot. Remove the plate. Keep the screw
(C).
Preparing the Printer
AB
Installing the NIC
These steps are illustrated on the opposite page.
4.Two posts are used for fastening the NIC to the Controller Board. Remove the screw from the lower one, loosen the screw of the upper one and rotate the small bracket (D). Avoid touching the Controller Board circuitry and components!
5.Remove the NIC from its protective bag (E). Handle the NIC only by its edges.
6.Hold the NIC so that its circuitry faces inside the printer and its LED’s face the back of the printer. Carefully align the standoff pin with the lower right corner of the NIC.
7.Plug the NIC’s connector to the Controller Board as shown (F).
8.Use the mounting screws and bracket to fasten the NIC to the standoff pins as shown. Attach the screw removed from the front in step 3 (G).
9.Slide the Controller Board back in the expansion slot. Reinstall and tighten the screws (H).
C
Network Slot
6 SuperScript Color Laser Network Guide