CHAPTER 4
NETWORK ADMINISTRATION PAGE
USING THE NETWORK
ADMINISTRATION PAGE
Each SuperScript laser printer has a
Accessing the Network Administration Page
You must assign an IP address to your printer’s NIC. Then you can use a web browser, such as Navigator or Internet Explorer, to access the Network Administration page.
note: See Chapter 3 for instructions on assigning the printer’s IP address.The printer’s IP address then appears on the Network Settings page under theTCP/IP Network Information section, protocol address entry.
To access the Network Administration page, open your browser by
1.Go to the URL Configuration Page, the URL is http://<IP address>/configure.html.
2.Click on the Network Administration link. This displays the Network Administration page.
You can access the following functions through the Network Administration page:
System Functions
Reset: Click here to reset the NIC and allow new settings to take effect. The NIC’s connection with the network is fully reinitialized, but its connection with the printer controller is not. To reset the connection with the printer controller, turn the printer off and on.
Factory Defaults: Click here to restore factory default values on all NIC parameters. You should restore factory defaults if you move the printer to a new network or if the NIC was set up improperly the first time. Remember
that this option clears all settings you have defined for the NIC. You must turn the printer off and on again for the factory default settings to take effect.
The Network Administration Page
17