Chapter 9 Configuration Setting (Common to All Units)
IV-179
9
9
9.
.
.8
8
8
R
R
Re
e
ep
p
pl
l
li
i
ic
c
ca
a
at
t
ti
i
io
o
on
n
n
P
P
Pa
a
ai
i
ir
r
r
B
B
Ba
a
at
t
tc
c
ch
h
h
S
S
Se
e
et
t
tt
t
ti
i
in
n
ng
g
g
Replication Batch Setting refers to setting replication, which is used for replications, collectively using the definition
file. For information on the replication functions, refer to the “Data Replication User’s Manual (Function Guide)”.
(1) Execution procedure
When Replication Batch Setting, click the [Replication Setting] button from “Configuration- [Setting Mode]” to
display the Replication Batch Setting dialog. An example of the Replication Batch Setting screen is shown in
Figure 9-35.
Figure 9-35 Example of Replication Batch Setting Screen
The screen above is operated in the same manner as described in 9.1.5 “Nickname Batch Setting”. However, the
detailed definitions of the file format and execution results are different.
For information on the file format, refer to Appendix F.2 “Pair Setting File”. The execution results are listed
below.
success: Successfully completed.
success(already): Already set.
failure(already): Failed, because the volume is already registered with another ATgroup.
failure(already RV): Failed, because this is already paired with another MV as an RV.
failure(ATgroup invalid): Failed, because the ATgroup name is invalid.
failure(ATgroup not exist): Failed, because this ATgroup does not exist.
failure(ATgroup not separated): Failed, because this ATgroup is not separated.
failure(ATgroup over): Failed, because no more ATgroup can be defined.