NEC LCD1990FXTM user manual Quick Start, Figure A.1

Quick Start

To attach the MultiSync® LCD monitor to your system, follow these instructions:

1.Turn off the power to your computer.

2.For use with the PC or MAC with DVI digital output: Connect the DVI signal cable to the connector of the display card in your system (Figure A.1). Tighten all screws.

For a PC with Analog output:Connect the 15-pin mini D-SUB signal cable to the connector of the display card in your system (Figure A.2). Tighten all screws.

For the MAC: Connect the MultiSync Macintosh cable adapter to the computer, then attach the 15-pin mini D-SUB signal cable to the MultiSync Macintosh cable adapter (Figure B.1).Tighten all screws.

Figure A.1	Figure A.2	Macintosh Adapter Figure B.1
		(not included)

NOTE: Some Macintosh systems do not require a Macintosh cable adapter.

NOTE: To obtain the MultiSync Macintosh cable adapter call NEC Display Solutions of America, Inc. (800) 632-4662.

3.Place hands on each side of the monitor. Tilt the LCD panel backwards to a 30-degree angle and lift up to the highest position. Connect all cables to appropriate connectors (Figure 4).

4.To keep the cables neatly organized, place them into the cable management system that is built into the stand.

Place the power cable into the specific hooks as indicated. (Figure 5).

Place the DVI cable and the 15-pin mini D-Sub cable into the hooks as indi- cated (Figure 5).

When using the monitor in Portrait mode, place the DVI cable and the 15-pin mini D-Sub cable into the hooks as indicated (Figure 6).

5.Cables should rest flat against the stand.

Make sure to leave enough slack in the cables so that the Tilt and the Raise and Lower functions of the monitor are not impeded.

3