50
Appendix –continued
Auto SW Sets the automatic adjustment level for Auto Adjust. The choices are “SIMPLE”,
(Analog input only) “FULL” and “DETAIL”. Press “+” or “-” to select. Refer to the below table.
Sets the automatic adjustment level as shown in the below table.
Auto Automatically adjusts the Image Position and H. Size settings and Fine settings.
(Analog input only) Press “SELECT” to activate Auto Adjustment.
H. Position Controls Horizontal Image Position within the display area of the LCD.
Press “+” or “-” to adjust.
V. Position Controls Vertical Image Position within the display area of the LCD.
Press “+” or “-” to adjust.
H. Size Adjusts the horizontal size of the screen.
(Analog input only) If the “AUTO Adjust function” does not give you a satisfactory picture setting, further
tuning can be performed using the “H.Size” function (dot clock). For this a Moiré test
pattern could be used. This function may alter the width of the picture. Use left/Right
Menu to center the image on the screen. If the H.Size is incorrectly calibrated, the result
would look like the drawing on the left. The image should be homogeneous.
When H.SIZE value is wrong. When H.SIZE value is improved. When H.SIZE value is correct.
Fine Improve focus, clarity and image stability by increasing or decreasing this setting.
(Analog input only) If the “Auto Adjust function” and the “H.Size” function do not give you a satisfactory
picture setting, fine tuning can be performed using the “Fine” function.By increasing or
decreasing this setting, focus, clarity and image stability can be improved. For this a Moiré test
pattern could be used. If the Fine value is wrongly calibrated, the result would look like the
drawing on the left. The image should be homogeneous.
When FINE value is wrong. When FINE value is correct.
Gamma Selection Allows you to manually select the brightness level of greyscale. There are five selections:
NO CORRECTION, 2.2, OPTION, PROGRAMMABLE and CUSTOM.
NO CORRECTION: No Correction possible.
2.2: The value is fixed at 2.2.
OPTION: There are two OPTION selections.
1: This setting is recommended when displaying full motion video such as a DVD or HDTV. The
grey area looks much brighter than NO CORRECTION setting.
2: This setting is near DICOM gamma and is preset at the factory. The luminosity difference
between gradations is set for optimal viewing of greyscale images.
PROGRAMMABLE: The brightness of greyscale can be changed to your preference by
downloading the application software from www.necmitsubishi.com.
CUSTOM: The gamma value is selectable from a range of 0.5 to 4.0 in 0.1 steps. When the
COLOR PRESET is sRGB, the value is fixed at 2.2 and NOT ADJUSTABLE.
Gamma Offset Adjusts the black level and is performed for both analog and digital signals. Black Level in
Tag1is effective only when the signal is analog. GAMMA OFFSET digitally adjusts the black
level after the signal is converted from analog to digital.
Size, Fine, Position Contrast Black Level, Long cable capability*
1
Time
SIMPLE O X X 1.5 seconds
FULL O O X 2 seconds
DETAIL O O O 10 to 20 seconds
*1: Black level, RGB sharpness, RGB delay and RGB position are adjusted using the “Long cable software”. To download the software, please visit www.necmitsubishi.com.
Tag4
Tag5
LCD2180UXManual1020.p65 10/21/03, 9:11 AM50